Rollershield Flashing Tape

 

Rollershield Flashing Tape is a lightweight roll flashing material with superior strength and the

ability to bridge most gaps or voids common in construction. It is used at flashing transitions with Master Wall Rollershield air & water barrier applications. The tape easily embeds into wet Rollershield and dries to a highly reinforced yet flexible flashing.

 

Tape Size

Rollershield Flashing Tape is available in the following size rolls:

  1. 4 inch x180 feet (10.2cm x 54.9m) Rollershield Flashing tape

Packaging

Rollershield Flashing Tape is packaged 18 rolls per case.

 

Coverage Estimate (4x8 sheets)

Square Footage x 0.37 = linear feet of tape Add linear footage around windows, doors and other openings. (coverage is not guaranteed)

 

 

Application Procedure

General - The substrate must be clean, dry, structurally sound and free of efflorescence, oil, grease, form release agents and curing compounds. Test painted surfaces to verify bond.

 

Job Conditions - Air and substrate temperature for application of Rollershield Flashing Tape must be 40°F (5°C) or higher.

 

Temporary Protection - Do not expose to direct sunlight for more than six weeks after installation.

 

Surface Preparation - Surface temperature must be above 40°F (5°C). Surface must be cured, clean, dry, structurally sound and free of efflorescence, oil, grease, form release agents, and curing compounds.

 

Approved Substrates

  • Gypsum sheathing (ASTM C79, C1177, C1396)
  • Dens Glass Gold®
  • GlasRoc®
  • FiberBond®
  • Durock®
  • PermaBase®
  • Securock®
  • Concrete
  • Brick
  • Masonry
  • Wood
  • Exterior Plywood
  • Oriented Strand Board and Metal
  • Contact Master Wall for other approved substrates.

 

Installation for Windows - The unique properties of the Rollershield air/water barrier system allows window flashing prior to the Rollershield wall application. Apply Rollershield using a trowel or brush at least 2 inches (51 mm) either side of the window opening. Immediately embed the Rollershield Flashing Tape into the wet Rollershield and smooth with a trowel, centering it over the corner. Use a "butterfly" at corners to complete the application making sure it covers all corner joints. For best results make sure the Rollershield covers the entire head, jamb and sill areas. The use of sill wedges or water stops is encouraged.

 

Sheathing Applications - Apply Rollershield at least 2 inches (51 mm) either side of the sheathing board joint. Immediately embed the Rollershield Flashing Tape into the wet Rollershield and smooth with a trowel, centering it over the joint. Lap Rollershield Mesh Tape 2 inches (51 mm) minimum Rollershield application can begin as soon as the Rollershield is dry to the touch.

Information contained in this product data sheet conforms to the standard detail recommendations and specifications for the installation of Master Wall Inc. products and is presented in good faith. Master Wall Inc. assumes no liability, expressed or implied as to the architecture, engineering, or workmanship of any project. This information may be concurrent with, or superseded by other applicable documents, such as specifications and details. Contact Master Wall Inc. for the most current product information.